Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns
A 1 AUX 9600/9600 - - - - - 0 0 0/0
Line 1, Location: "", Type: ""
Length: 24 lines, Width: 80 columns
Baud rate (TX/RX) is 9600/9600, no parity, 2 stopbits, 8 databits
Status: Ready, Active, Async Interface Active
Capabilities: Hardware Flowcontrol In, Hardware Flowcontrol Out
Line is permanent async interface
Modem state: Ready
Line is running PPP for address 200.2.2.1.
0 output packets queued, 1 input packets.
Async Escape map is 00000000000000000101000000000000
Modem hardware state: CTS* DSR* DTR RTS
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer
Session Dispatch 00:10:00 never none not set
Idle Session Disconnect Warning never
Modem type is unknown.
Session limit is not set.
Time since activation: never
Editing is enabled. History is enabled, history size is 10.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed transports are pad v120 telnet rlogin mop. Preferred is telnet.
No output characters are padded
No special data dispatching characters
Router#sh line
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns
* 0 CTY - - - - - 0 0 0/0 A
1 AUX 9600/9600 - - - - - 0 0 0/0
2 VTY - - - - - 0 0 0/0
3 VTY - - - - - 0 0 0/0
4 VTY - - - - - 0 0 0/0
5 VTY - - - - - 0 0 0/0
6 VTY - - - - - 0 0 0/0
Router#sh int s0
Serial0 is up, line protocol is up
Hardware is HD64570 Internet address is 200.1.1.2/24
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
LCP Open
Open: IPCP, CDPCP
Last input 00:00:05, output 00:00:05, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1 (active/max active/threshold)
Reserved Conversations 0/0/64 (allocated/max allocated)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
74 packets input, 2733 bytes, 0 no buffer
Received 74 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
75 packets output, 3093 bytes, 0 underruns
0 output errors, 0 collisions, 4 interface resets 0 output buffer failures,
0 output buffers swapped out
3 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
Router#sh int a1
Async1 is up, line protocol is up
Hardware is Async Serial Internet address is 200.2.2.2/24
MTU 1500 bytes, BW 9 Kbit, DLY 100000 usec, rely 255/255, load 1/255
Encapsulation PPP, loopback not set, keepalive not set
DTR is pulsed for 60 seconds on reset
LCP Open
Open: IPCP, CDPCP
Last input 00:05:23, output 00:00:10, output hang never
Last clearing of "show interface" counters never
Input queue: 1/75/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1 (active/max active/threshold)
Reserved Conversations 0/0/64 (allocated/max allocated)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
33 packets input, 1125 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
31 packets output, 2888 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
- 网络技巧:如何修改路由器和交换机的密码
- HDSL宽带接入路由的配置
- 苹果无法加入无线网络是怎么回事
- 路由器防火墙配置命令
- 路由再发布
- ADSL猫 路由设置方法
- Diffserv体系结构中路由器的实现
- 路由器丢失PASSWORD的恢复
- 臭氧防治韭蛆技术
- 路由器log设置
