IP网络路由技术简介及Cisco路由器配置(11)

5 minute output rate 0 bits/sec, 0 packets/sec
97 packets input, 3606 bytes, 0 no buffer
Received 97 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
98 packets output, 3979 bytes, 0 underruns
0 output errors, 0 collisions, 14 interface resets
0 output buffer failures, 0 output buffers swapped out
7 carrier transitions DCD=up DSR=up DTR=up RTS=up CTS=up
Router#ping 200.1.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 200.1.1.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 32/32/32 ms
Router#
(三)、Hayes modem的设置
1、RouterA(caller)
at
OK
at&v
ACTIVE PROFILE: B1 B16 B30 B41 B52 B60 B70 B75 B80 E1 L2 M1 N1 P Q0 V1 W0 X4 Y0 &A0 &B1 &C1 &D3 &G0 &K3 &L0 &Q5 &R0 &S0 &T4 &U0 &X0 &Y0 S00:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:050 S08:002 S09:006 S10:014 S11:095 S12:050 S25:005 S26:001 S36:007 S37:000 S38:020 S46:002 S48:007
STORED PROFILE 0: B1 B16 B30 B41 B52 B60 B70 B75 B80 E1 L2 M1 N1 P Q0 V1 W0 X4 Y0 &A0 &B1 &C1 &D3 &G0 &K3 &L0 &Q5 &R0 &S0 &T4 &U0 &X0 S00:000 S02:043 S06:002 S07:050 S08:002 S09:006 S10:014 S11:095 S12:050 S25:005 S26:001 S36:007 S37:000 S38:020 S46:002 S48:007 S108:001
STORED PROFILE 1: B1 B16 B30 B41 B52 B60 B70 B75 B80 E1 L2 M1 N1 P Q0 V1 W0 X4 Y0 &A0 &B1 &C0 &D0 &G0 &K3 &L0 &Q5 &R0 &S0 &T4 &U0 &X0 S00:000 S02:043 S06:002 S07:050 S08:002 S09:006 S10:014 S11:095 S12:050 S25:005 S26:001 S36:007 S37:000 S38:020 S46:002 S48:007 S108:001
TELEPHONE NUMBERS:
&Z0=402
&Z1=
&Z2=
&Z3=
OK
AT&FS0=1&C1&D3&W
2、RouterB(Server中心)
at&fe0q1&w或
at&fs0=1&d3&w